Contact Type:

Pneumatic

Pressure Rating:

15 Bar max

Body Material:

Stainless steel

Contact method of termination:

Installation into module You undo the two screws on the side of the module and remove the clamping strip. Then undo the three screws on the front of the module. Remove the metal comb unit from the back. Insert the contacts into the module. Slide the comb back into place to trap the contacts. Fasten the three screws back up to hold the comb to the back of the module. Then slide in the clamp strip with the two screws. It is the same for the receiver and ITA modules. Please note that sometimes the clamping strip gets trapped or wont slide in place just loosen the three comb screws half a turn and then retighten when it is in position.